Xlr Splitter

Part #: SES-AES-EBU-Y

List Price $69.95

…simple to deploy, it is a winner on every job and that best describes our exclusive Digital Audio AES EBU XLR Y Splitter cable. This low cost cable is a state-of-the-art 1X2 digital audio splitter. Although it does not require external power as it employs our custom designed transformer to deliver performance…

Part #: SPLIT-6

List Price $90.72

Whirlwind SPLIT 6 Line Level Parallel Splitter Use this handy box when you need to split a line level signal up to 6 times*. Features 1 female XLR input wired to 6 male XLR outputs. Perfect when adding extra amplifiers to a system, connecting multiple powered speakers, splitting intercom lines, etc…

Part #: ETS-PA832

List Price $95.00

…for a distribution amplifier in many applications * Superb impedance matching * Rugged metal cases and chassis * Made in USA. 100% QA. Specifications * Bandwidth: 200 kHz to 10 MHz * Connectors: (3) XLR per channel * Impedance: 110 Ohm * Insertion Loss: PA830 AES/EBU Splitter, F-XLR to (2) M-XLR PA832AES…

Part #: ATI-DA206

List Price $699.00

The DA206 is an ideal analog audio DA for every application and every budget. It lets you avoid RF and hum pick-up problems from noisy, lossy splitters, prevent hard-to-find shorts from multiple taps on critical lines, boost mixer outputs, drive long lines, and eliminate rolloffs and distortion from…

Part #: DA-2

List Price $693.60

The DA-2 is a two channel XLR audio distribution amplifier with four outputs per channel. Each output has its own level control and clip indicator light. The input signal is monitored by a signal-present LED and a clip LED. The unit provides a headphone output which can be switched to monitor either…

Part #: ARX-BSX-16

List Price $2,095.00

…Transformer Isolated Active Broadcast Splitter * 16 way active press/broadcast splitter with transformer isolation * Splits 18 Line level out; splits 916 switchable mic or line level * Dual inputs with individual Gain and Level controls * Dual Loop Outputs * Additional XLR PA Output connector on rear * Ultra…

Part #: JEN-MS2XX

List Price $219.95

…shielded windings for maximum R.F. interference rejection * High quality gold plated connectors for long term reliability * Available with a choice of XLR, RCA, 1/4" Phone Jack or BNC connectors * Unpluggable screw terminal strip for easy "Home" to "Road" changeovers * Convenient 7.0" W x 3.5" D x 1.6"…

Part #: RU-MLD4T

List Price $526.76

Radio Design Labs RDL RU-MLD4T Microphone / Line Distribution Amplifier - 1x4 with Transformer The RU-MLD4 is a four channel audio distribution amplifier. The input and all four outputs may be connected through the front-panel XLR jacks or on the rear panel detachable terminal blocks. The input accepts…

Part #: ETS-PA830

List Price $95.00

…for a distribution amplifier in many applications * Superb impedance matching * Rugged metal cases and chassis * Made in USA. 100% QA. Specifications * Bandwidth: 200 kHz to 10 MHz * Connectors: (3) XLR per channel * Impedance: 110 Ohm * Insertion Loss: PA830 AES/EBU Splitter, F-XLR to (2) M-XLR PA832AES…

Part #: RD1-BX5

List Price $249.95

Laird RD1-BX5 24-Volt Twin Output 3-Pin XLR Power Splitter Box Great for Adding Additional 24 Volt Cameras & Accessories! Use one 24 Volt power supply and split it into two with these passive splitters! Power digital cinema equipment, 3D rigs and more with this handy box. The RD1-BX5 follows 24 volt…

Part #: WOH-AMP1-DA106

List Price $2,150.00

The AMP1-DA/106 audio monitor provides self-powered, full-fidelity stereo monitoring in the smallest rack space possible (1U). The unit features two selectable AES input sources on unbalanced BNC connectors and a stereo analog input source on two balanced XLR connectors, 2-position AES source select…

Part #: ES 217

List Price $195.00

…accessible on terminal blocks for simple "permanent" installations. Or, if option "XLR" is specified, all inputs and outputs are available on XLR connectors for easy disconnect/reconnect. The ES-217 is an Audio DA with four independently adjustable (via the top-mounted Gain controls) outputs, while…

Part #: TW-7W

One 3-Pin XLR female into seven 3-Pin male XLR out (half-rack wide).

Part #: MS-2

List Price $120.99

For splitting signal from a low-Z microphone between 2 mixers. Female XLR type input; direct and isolated male XLR type outputs; isolated output has ground lift switch. Uses MBT-1 transformer (150 Ohms 1:1).

Part #: VM-1110XL

List Price $660.00

…Distribution Amp The VM-1110xl is a high performance distribution amplifier for balanced mono audio signals on XLR connectors. It can be configuredas a 1x5 distribution amplifier for stereo balanced audio signals. Features: * Level (Gain) Controls. * Dual Mode - Configure as 1:10 (mono) or 1:5 (stereo) DA. * S…

Part #: MS-20C

List Price $60.00

Rolls MS20c Mic Splitter / Combiner / Isolator The MS20c Splitter / Combiner / Isolator will split a single balanced XLR signal into two isolated signals, combine two balanced XLR signals together into a single, or simply isolate a balanced line for buzz or hum elimination. Please note that when combining…

Part #: DEQ-2496

List Price $653.99

…preset dumps and system updates. The DEQ2496 also boasts balanced inputs and servobalanced outputs with gold-plated XLR connectors, stereo aux output, AES/EBU and S/PDIF inputs and outputs (XLR and optical). The internal switch-mode power supply assures maximum flexibility (100 - 240 V~), noise-free audio…

Part #: RAD-JRAK

List Price $165.00

…best DIs now in a high density rack * Mount up to 8 Radial DI's or splitters per 2RU space * Reconfigure for different combinations of in seconds * DI's can be front or rear mounted * Mix and match passive or active DI's or splitters * Total flexibility never before available in a rackmount DI The Radial…

Part #: RAD-JS3

List Price $300.00

…mounted * Ultra rugged 14-gauge steel construction The Radial JS2 and JS3 are Jensen Transformer equipped mic splitters that allow a balanced source to drive multiple destinations via standard XLR connectors. These passive devices feature a premium nickel laminated core transformer for exceptionally low…

Part #: GXY-JIBC

List Price $39.99

Two XLR inputs and one XLR output. Combines mic signals. Also permits phantom power for both microphones if available from the console. Add an additional microphone to a (or other powered monitor) when all inputs are in use. Permits phantom power to go to both microphones if available from the console…

Part #: RAD-JS2

List Price $250.00

…mounted * Ultra rugged 14-gauge steel construction The Radial JS2 and JS3 are Jensen Transformer equipped mic splitters that allow a balanced source to drive multiple destinations via standard XLR connectors. These passive devices feature a premium nickel laminated core transformer for exceptionally low…

Part #: KR-104B

List Price $495.00

Kramer 104B 1x4 Microphone Distribution Amplifier The Kramer 104B is a high quality distribution amplifier for balanced mono microphone signals on XLR connectors. It takes one microphone input and distributes the signal to four identical outputs. * Mic Input Selector - Condenser or dynamic. * Phantom…

Part #: MS3

List Price $147.99

For splitting signal from a low-Z microphone between 3 mixers. Female XLR type input; direct and 2 isolated male XLR type outputs; isolated outputs have ground lift switches. Uses MBT-2 transformer (150 Ohms 1:1:1).

Part #: TCM-HS-8

List Price $6,999.99

…surround recording to post production playback of HS-P82 location recordings, the HS-8 fits a variety of multitrack roles first pioneered by TASCAM's DA-88 recorders. Also true to TASCAM tradition, audio is top-quality throughout with up to 192kHz/24-bit recording. Like the HS-P82, the HS-8 uses a color…