Telex TR-700-C3 Belt Pack - A4M Headset Jack C3 Band

ITEM #: TX-TR-700-C3 MFG #: TR-700-C3

Primary Image

This item is no longer available.
Ask a Markertek Expert if you need assistance finding an appropriate substitute.

(800) 522-2025Email

Items similar to the TX-TR-700-C3

TR-700-C3 - Overview

The Telex RadioCom BTR-700 UHF Synthesized Wireless intercom systems offer the ultimate in reliable, high performance, high fidelity full duplex communications.

The BTR-700 system includes the BTR-700 frequency agile base station, working with up to four TR-700 frequency agile beltpacks. The BTR-700 base station provides full duplex communications with the beltpacks.

The BTR-700 system is perfectly suited for stand-alone operation and also can interface with Audiocom (Telex), RTS TW, Clear-Com as well as RTS Matrix systems and other 4 wire communications systems. In addition to the external intercom systems interfaces listed above, the system provides connections for auxiliary balanced audio input and ouput.

The RadioCom BTR series has been designed for reliable, efficient operation. Operating in the 518 to 868 MHz range, the units operate reliably at line-of-sight distances of 1,000 feet. With available antenna systems from Telex, the effective operating range can be extended. The high efficiency beltpacks provide 12-14 hours of uninterrupted operation using standard alkaline batteries.

Bat/Overmod Light (BAT/OM)
Light will flash once when unit is turned on if the battery is good. If the light stays on, battery is low. If the light does not flash, battery is dead. A normal microphone gain setting will cause the LED to flash at the beginning of most words at normal speech levels. If the gain is too high, the LED will be red during the complete word at normal speech levels.

On/Off Volume Control
Turns the beltpack power on and controls head set volume

Talk Button
Press to enable the audio path to either Intercom Channel A or B or A + B, from the local headset microphone. The associated "TALK" LED, #6, will turn red when enabled. A quick press and release latches the talk function, unless latching has been disabled. Holding the button for over 1/2 second, will cause the audio path to be enabled only for as long as the button is held. If the talk function is latched on, pressing the talk but ton again will turn it off.

Talk Light
Will turn red when enabled by associated TALK or WTA button


PLEASE NOTE: Although the 700 and 800 series models "appear" to be the same there are minor differences in the model#'s which could result in a mismatch if ordered incorrectly. Make sure you have ordered the correct Base Station,Transceiver and headset that match your needs and match each other! Things to look for are matching frequency bands and headset interconnects.

BTR-700 UHF Single Channel Wireless Synthesized Base Station with A4M headset connector.
BTR-700-RTS UHF Single Channel Wireless Synthesized Base Station with A4F headset connector.
BTR-700-RTS 5-Pin UHF Single Channel Wireless Synthesized Base Station with A5F headset connector.
TR-700 UHF Single Channel Wireless Synthesized Transceiver with A4M headset connector.
TR-700-RTS UHF Single Channel Wireless Synthesized Transceiver with A4F headset connector.
TR-700-RTS 5-Pin UHF Single Channel Wireless Synthesized Transceiver with A5F headset connector.

This item is just one component of a larger system. Please refer to the diagram for ideas and recommendations for your Telex intercom system. Diagram shown is a recommendation for a small sport setup for a school.

California Residents:
WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov